PROTOTIPE MESIN SANTAN KELAPA BERBASIS PLC OUTSEAL
DOI:
https://doi.org/10.61722/jssr.v4i2.9253Keywords:
PLC Outseal, Arduino Uno, Load Cell, Ultrasonik, HMI, Mesin SantanAbstract
This research aims to design and realize a prototype of a coconut milk machine based on Outseal PLC that integrates the grating and squeezing processes in one automatic system. The system uses Outseal Mega V.2 PLC as the main controller with Arduino Uno support for sensor reading. A load cell sensor is used to detect the weight of 1 kg of grated coconut as a parameter for the process transfer to the squeezing stage. The test results show that 1 kg of grated coconut produces approximately ½ liter (500 ml) of coconut milk. An ultrasonic sensor is used to detect the height of the coconut milk surface in the container, which is approximately 14.8 cm at a volume of 500 ml as the system's stop limit. The process of making coconut milk using the machine takes approximately 40 minutes, faster than the manual process which takes approximately 60 minutes. The results of the study indicate that the tool is able to increase time efficiency and reduce manual work processes in making coconut milk.
References
Akbar, A. F., Hartono, P., & Raharjo, A. (2021). Perencanaan Mesin Pemarut Kelapa Beserta Pemeras Hasil Parutan. https://jim.unisma.ac.id/index.php/jts/article/view/5757
Arifin, T. N., Febriyani Pratiwi, G., & Janrafsasih, A. (2024). Sensor Ultrasonik Sebagai Sensor Jarak. Jurnal Tera, 2(2), 55–62. http://jurnal.undira.ac.id/index.php/jurnaltera/
Badan Pusat Statistik Provinsi Kalimantan Barat. (2023). https://kalbar.bps.go.id/id/statistics_table/2/MjUwiz1963D/produksi-perkebunan-rakyat.html
Data Sheet Arduino Uno. (2024). https://docs.arduino.cc/hardware/uno-rev3
Data Sheet Sensor Loadcell. (2021). https://joy-it.net/en/products/SEN-HX711-05
GmbH, S. E. (2021). With Amplifier Board. 8, 47506.
Haddad, A. (2025). Rancang bangun alat pendeteksi tanah longsor berbasis iot dan notifikasi telegram.
Lubis, F. B., & Yanie, A. (2022). Implementasi Pulse Width Modulation (PWM) Pada Penyaluran Limbah Cair Pupuk Kelapa Sawit Berbasis Arduino. JET (Journal of Electrical Technology), 7(2), 39–46. https://doi.org/10.30743/jet.v7i2.5394
Malik Al Jabbar, H., & Fahmi Hakim, M. (2023). Analisis Efektivitas Daya Dan Energi Pada Sistem Pembersih Solar PV 2 × 50 Wp dengan Metode Lateral Movement. Jurnal Teknik Ilmu Dan Aplikasi, 4(2), 38–44.
Nur, A., Ahmad, A. S., & Nur, M. (2022). Mesin Pemarut Kelapa Otomatis Berbasis Mikrokontroler Avr Atmega328Pu. Mechatronics Journal in Professional and Entrepreneur, 4(1), 17–20.
Sanita, & Putri, Y. K. (2023). RANCANGAN MESIN PEMARUT DAN PEMERAS SANTAN KELAPA.
Sutrisno, Witjahjo, H., & Permana, R. (2023). Rancang Bangun Mesin Pemarut dan Pemeras Santan Kelapa. Jurnal Ilmiah Bidang Ilmu Teknik, 240–250. https://ojs.stttexmaco.ac.id/index.php/infotex/article/view/53
Syahputra, K. A., & Bukit, F. R. A. (2022). Perancangan HMI (Human Machine Interface) sebagai pengontrol dan pendeteksi dini kerusakan kapasitor bank berbasis PLC [Design of an HMI (Human Machine Interface) as a controller and early detector of capacitor bank damage based on a PLC]. Journal of Energy and Electrical Engineering (Jeee), 101(2), 101–105.
Wijonarko, S., Warman, A., & Sitorus, A. K. (2021). Dissipation of Electrical Energy into Heat Energy in Web-Based Rainfall Meter Microcontrollers. Journal of Technomaterial Physics, 3(1), 57–64. https://talenta.usu.ac.id/JoTP/article/view/5541
Downloads
Published
Issue
Section
License
Copyright (c) 2026 JOURNAL SAINS STUDENT RESEARCH
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
